Pool Alarm, Surface Mount Door Alert (Instant On Or 7 Second Delay) - Closed Loop

NPNB-289N-2

Security Savvy

  • $89.94
    Unit price per 


Pool Alarm, Surface Mount Door Alert (Instant On Or 7 Second Delay) - Closed Loop

The new DOOR ALERT/POOL ALARM was designed as an aid for prevention of an unattended access to a pool/spa area by a small child. Monitoring all doors or windows with CLOSED LOOP magnetic reed switches, the DOOR ALERT/ POOL ALARM will sound an alarm should anyone too small to manage the adult pass thru feature attempt access to the pool/spa area. For maximum protection all moveable openings should be protected in such a manner by the DOOR ALERT/POOL ALARM.

The Pool Alarm can be operated with an on-board 9 volt battery with a 12 volt externally supplied DC power source, in which case the battery will perform a back-up function should the externally supplied source fail for any reason. Both power sources have been designed to maintain a maximum sound pressure level. Should the battery voltage drop below 7 volts while in backup mode, a low battery mode will be initiated and the unit will sound 2 beeps approximately every 3 seconds for one to two weeks prior to total battery failure. Battery must be replaced at this time. It is suggested that some type of surge protection, such as the NPNB-CS-1 Current Sensor, be used between the power supply and all Pool Alarms using external power

NOTE: Unit will function at minimum 5VDC at a very limited sounder volume. This power level is considered total battery failure.

DISCLAIMER: The Door Alert/Pool Alarm is not a life saving device. Its™ intent is to serve strictly as a monitoring device on doors and windows to help prevent unattended access to pool and spa areas

WARNING: THIS IS NOT A LIFE SAVING DEVICE.

Features

  • Exceeds operational requirements of Model Barrier codes
  • Microprocessor Controlled
  • Monitors entry to Pool and Spa areas
  • Instant on or 7 second delay models available
  • Surface Mount
  • 15 second adult shunt
  • Built-in back-up battery capable
  • Must be hard wired to remote 12 volt maximum 500 mA source or to plug in power source. Applied voltage must not exceed 15 VDC. Battery for backup only.
  • Made In U.S.A.

Installation Instructions:

The DOOR ALERT/POOL ALARM mounts easily to the wall by any door or window which allows access to the pool/spa area. Using an CLOSED LOOP magnetic reed switch, the unit will detect and announce an open access by sounding a loud continuous alarm. Two timed options are offered: A maximum seven (7) second delay mode prior to sounding upon door opening, or an instant alarm sounding upon activation. All versions incorporate a built-in pass thru feature and deactivation button to allow adult access without alarm sounding. Although the DOOR ALERT/POOL ALARM cannot be turned off, this feature will simply deactivate the alarm function for a maximum of fifteen (15) seconds. During this time span the adult must exit and close the door before alarm sounds. Once the alarm is sounding it can not be silenced by simply closing the door. The deactivation button must also be depressed. The sounder cannot be disabled by holding down the deactivation button.

If a screen is present on the opening giving access to the pool, a second CLOSED LOOP switch should be mounted on it and both switches wired in parallel. This configuration will allow the door to be open for ventilation since the unit will activate only when both the screen and the door or window are opened. If multiple openings lead to the area, the DOOR ALERT/POOL ALARM can monitor all by installing CLOSED LOOP switches which are wired in series. In this way, any opening will be detected by the DOOR ALERT/POOL ALARM. A single deactivation button can also be wired at each opening to utilize the pass thru feature. Additional remote sounders may be wired in to extend sounder coverage. Please contact your local us for information on remote options.

Package

  • 1 x Pool Alarm